INSTALL SUPER START
1.
1. Remove the fuel line from the carburetor.
2.
2. Remove the manifold spring (179) and separate the
manifold (114) from the engine.
3.
3. Remove the air filter assembly from the carburetor.
4.
4. Detach the throttle linkage from the carburetor and rotate it
out of the way.
5.
5.
Remove the (4) 3x12mm engine mount screws (MM) that
attach the engine to the engine mount plates (85). Be careful
not to lose the 3mm lock washers on the engine mount screws.
6.
6.
Remove the engine from the chassis.
7.
7.
Remove the (3) 2.6x8mm screws that hold the recoil to the
engine and remove the recoil assembly. Tip: Make sure to
take note of the direction of the one-way bearing when
removing it from the engine.The round portion of the one-
way bearing faces the engine.
8.
8. Install the one-way bearing into the Super Start system
and install the Super Start onto the engine.
9.
9. Secure the Super Start to the engine using the included
2.6x 8 Phillips head screws and washers.
Important!: Apply thread lock to the screws before installing
them to prevent them from coming loose while running.
10.
10.
Re-install the engine into the chassis and secure it in
place with the (4) 3x12mm engine mount screws (MM)
with 3mm washer (KK). Tip: Use a small amount of thread
lock to keep the engine mount screws from falling out.
11.
11.
Reconnect the throttle linkage to the carburetor.
12.
12.
Re-install the air filter assembly.
13.
13.
Re-install the manifold (114) and secure it to the engine
with the manifold spring (179).
14.
14.
Reconnect the fuel tubing to the carburetor.
Tools Required: Phillips Screwdriver (DTXR0182), 2mm Hex Wrench (DTXR0289).
REPLACE SERVO SAVER
1.
1. Remove the two 3x15mm screws (E) that connects the steering tie-rods
(170 & 172) to the steering draglink (71).
2.
2. Remove the (2) 3x12mm pan head screws (D) that attaches the draglink
to the bellcranks. Be careful not to lose the draglink bushings (70).
3.
3. Remove the 3x15mm pan head (E) that attaches the servo linkage to
the servo saver.
4.
4. Remove the six screws that hold the front skid plate (5) to the chassis
and remove the skid plate from the chassis.
Required Tools: Phillips Screwdriver (DTXR0182)
NOTE: SOME PARTS
REMOVED FOR CLARITY
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels