Duratrax Warhead Manuel d'utilisateur télécharger pdf (Page 15)

REMOVE ENGINE

4. Remove the manifold

spring (179) and

separate the manifold

(114) from the engine.

1. Remove the fuel line from

the carburetor.

2. Remove the air filter

assembly from the carburetor.

5. Detach the throttle linkage from the

carburetor and rotate it out of the way.

Required Tools:

2.5mm Ball Driver (DTXC0295)

Long Nose Pliers (DTXR0300)

10.

10. Re-attach the suspension arms (23& 26) to the front bulkheads (19&20) using the upper (35) and lower (34) hinge pins.

11.

11. Secure the hinge pins in place using the 3 mm e-clips (H).

12.

12. Re-attach the front shock tower (16) to the front bulkheads (19&20) using the four 3x12mm pan head screws (D).

13.

13. Re-install the lower bulkhead brace (40) and the front differential skid plate (41) onto the bottom of the bulkheads.

14.

14. Re-attach the front bumper by installing four 3x12mm pan head screws (D) through the front bumper mounts (53 &39)

and into the front bulkheads (19 & 20).

15.

Re-install the front center drive shaft (4) between the transmission and the front differential.

16.

Re-attach the front end of the truck back onto the chassis. The 3x15mm button head hex screws (NN) go in the top hole

on each side and the bottom two holes on each side get 3x10mm button head hex screws (QQ).

17.

Re-attach the steering tie-rods to the bottom of the steering draglink (71) using two 3x15mm screws (E).

INSTALL FUEL LINE CLIP

1. Remove the fuel line from the carburetor

and the fuel tanks.

2. Remove the header tank from the chassis.

3. Install the new fuel line and fuel line clip

onto the carburetor and fuel tank.

3. Remove the header tank

from the side frame.

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Duratrax Warhead Manuel d'utilisateur Page 15