Duratrax Warhead Manuel d'utilisateur télécharger pdf (Page 12)

INSTALL 3-SHOE CLUTCH

1. Install the new 3 pin flywheel. Make sure the brass collet is still on the crankshaft.

2. Re-install the clutch nut/pilot shaft (93). Tip: Make sure the clutch nut/pilot shaft is

fully tightened on the engine’s crankshaft to prevent it from coming loose later.

3. Install the new clutch shoes and springs onto the 3 pin flywheel.

5. Re-install the spacer (M)

and 4mm e-clip (L).

4. Re-install the clutch bell

and bearings onto the

clutch nut/pilot shaft.

REMOVE FRONT END

1. Remove the 5mm flanged nuts (S) from the front axles (45).Then, remove the wheels/tires.

2. Remove the two 3x15 pan head screws (E) that attach the steering tie-rods to the draglink (71).

3. Remove the six screws (two NN (top) and four QQ) that attach the chassis (1 & 2) to the front

bulkhead (19 & 20) and remove the front end of the truck from the chassis (1 & 2).

Required Tools:

Phillips Screwdriver (DTXR0182),

2mm Hex Wrench (DTXR0176),

8mm Wrench (4-Way included with Warhead)

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Duratrax Warhead Manuel d'utilisateur Page 12