REPLACE FUEL TANK
3.
3. Disconnect the fuel line from the bottom of the tank and from the fuel tank lid.
4.
4. Connect the fuel lines to the new tank. Make sure the pressure line (the line attached to the tuned pipe) is connected to the
nipple located on the fuel tank lid and the carburetor line is attached to the bottom of the tank.
5.
5. Make sure you re-install the (3) rubber O-rings (VV) between the engine mount (84) and the fuel tank (8). Tip: Apply a
small amount of grease to the O-rings (VV) to help hold them in place so they line up with the tank mounting screws (UU).
6.
6. Install the (3) 3x12mm flat head machine screws (UU) through the engine mount (84), O-rings (VV) and into the fuel tank (8).
Tip: Do not fully tighten the screws (UU). Over-tightening the screws will smash the O-rings (VV) and render them useless.
Required Tools: Phillips Screwdriver (DTXR0182)
• Important!: Drain
the fuel tank.
1.
1. Remove the (3) 3x12mm flat
head machine screws (UU)
located on the bottom of the
fuel tank (8).
2.
2.
Gently remove the fuel tank (8)
from the chassis.When
removing the tank from the
chassis, be sure not to lose the
(3) rubber O-rings (VV) located
between the engine mount (84)
and the bottom of the fuel tank
(8).The O-rings help reduce
vibration in the fuel tank.
8.
8. Install the bellcrank assembly back onto the bellcrank posts (78).
9.
9. Re-install the skid plate onto the chassis and secure in place with the (6) screws previously removed.
Important: The bellcrank posts (78) must key into the front skid plate (5) for a proper fit.
10.
10. Re-install the steering draglink (71) onto the new bellcranks using the two 3x12mm pan head screws (D).
Tip: Make sure the bushings are properly seated before installing the screws.
11.
11. Re-attach the steering tie-rods to the bottom of the steering draglink (71) using two 3x15mm screws (E).
5.
5. Remove the bellcrank assemblies from the bellcrank posts (78).
6.
6. Disassemble the servo saver side of the bellcranks and re-
assemble using the new upper (73) and lower (74) bellcranks.
7.
7. Install the new bellcrank bushings (163) into the parts as shown.
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels